D-Link DXS-3600-16S Manual page 460

no ip pim register-suppression
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim register-suppression
DXS-3600-32S(config)#
47-6 ip pim rp-address
This command is used to create a static RP in PIM-SM. To delete the static RP entry, use the no form of this command.
ip pim rp-address RP-ADDRESS [ACCESS_LIST]
no ip pim rp-address RP-ADDRESS
Parameters
RP-ADDRESS
ACCESS_LIST
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the value of the register suppression time. The range of this value is 11-
255 seconds.
60 seconds.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
When a DR receives the register-stop message, it will start the suppression timer.
During suppression period, a DR stops sending the register message to the RP.
Use the command on the first hop router.
Please be noted, the parameter Register Probe Time in RFC 4601 is fixed to 5.
Because the value of the Register Probe Time must be less than half the value of the
Register Suppression Time to prevent a possible negative value in the setting of the
Register-Stop Timer, the minimal value for Register Suppression Time is 11.
To verify your configuration, use command show ip pim.
This example shows how to configure the PIM register suppression to be 100
seconds.
register-suppression 100
This example shows how to restore the default value.
Specifies the IP address of the RP.
Specifies the name of the access list.
No any static RP entry.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
452