D-Link DXS-3600-16S Manual page 426

Example
>reload
Save current settings before system restart?(y/n) y
Please wait, the switch is rebooting...
41-3 password-recover
This command is used to enable the password recover option. The no form of this command is usd to disable this
option.
password-recover
no password-recover
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure ter
DXS-3600-32S(config)#no password-recover
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure ter
DXS-3600-32S(config)#password-recover
DXS-3600-32S(config)#
41-4 show password-recover
This command is used to display the password recover option's state on the switch.
show password-recover
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show password-recover
Running Configuration
NV-RAM Configuration
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to reboot the switch, using the reload command.
None.
By default, this option is enabled.
Global Configuration Mode.
Level: 15
This command is used to enable the password recover option. The no form of this
command is usd to disable this option.
This example shows how to disabled the password recover option.
This example shows how to enable the password recover option.
None.
None.
EXEC Mode.
Level: 1
This command is used to display the password recover option's state on the switch.
This example shows how to display the password recover option's state.
:Enabled
:Enabled
418