D-Link DXS-3600-16S Manual page 360

Parameters
interface
IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls label protocol ldp
DXS-3600-32S(config-mpls-router)# transport-address 192.168.0.1
DXS-3600-32S(config-mpls-router)#
38-17 backoff maximum
This command is used to configure the maximum back-off delay time. Use the no form of this command to restore the
default value.
backoff maximum SECONDS
no backoff maximum
Parameters
SECONDS
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to use the IP address of the corresponding interface as the transmission
address for the session on each interface.
Specifies that all sessions should use this specified IP address as the transmission
address uniformly.
Use the LSR ID as the transport-address.
MPLS Router Configuration Mode.
Level: 15.
This command is used to configure the LDP transport address. The transport
address is used to establish LDP TCP connection. By default, the LSR ID is used as
the transport address by all interfaces.
If you configure the transport address to "interface", the IP address of each interface
is used as the transport address. If you configure the transport address to a specified
IP address, this address is used as transport address by all interfaces.
Note: If LDP is running, configuring the transport address will lead to LDP sessions
restarting.
Note: If LDP is running, link-down or deleting the interface which IP address is used
as the transport address will lead to the LDP session down. It is suggested to use the
loopback interface as the transport address.
This example shows how to configure the transport address to 192.168.0.1.
Specifies the maximum back-off delay time. The range is 120-65535 seconds
600 seconds.
MPLS Router Configuration Mode.
Level: 15.
352