D-Link DXS-3600-16S Manual page 210

show ip dhcp relay option60 [identifier desc 255 | default]
Parameters
desc 255
default
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip dhcp relay option60
Default Servers:
10.90.90.90
Matching Rules:
String
-------
MSFT 5.0
Total Entries : 1
DXS-3600-32S#
13-8 ip dhcp relay option61
This command is used to enable the DHCP relay Option 61 function. The no form of this command is used to disable
the DHCP relay Option 61 function.
ip dhcp relay option61
no ip dhcp relay option61
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp relay option61
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the specified string.
Specifies the default relay server configuration.
None.
Privileged Mode.
Level: 2
This command is used to show the entries of the DHCP relay Option 60.
This example shows how to show the result of the show ip dhcp relay option60
command.
Match Type
---------
Exact Match
None.
By default, this option is disabled.
Global Configuration Mode.
Level: 8
When the Option 61 is enabled, if the packet contains Option 61, it will be based on
the Option 60 field to determine the relay server.
You can verify your settings by entering the show ip dhcp relay option61
command.
This example shows how to enable the ip dhcp relay option61 function.
IP Address
---------
10.90.90.90
202