D-Link DXS-3600-16S Manual page 415

40-31 debug ip ospf
This command is used to turn on OSPF debug function. Use the no form of this command to turn off OSPF debug
function.
debug ip ospf
no debug ip ospf
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf
DXS-3600-32S#
40-32 debug ip ospf neighbor
This command is used to turn on the OSPF neighbor state debug switch. Use the no form of the command to turn off
the OSPF neighbor state debug switch.
debug ip ospf neighbor
no debug ip ospf neighbor
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf neighbor
DXS-3600-32S#
NBR 2.2.2.2 state change from LOADING to FULL tic 100
NBR 3.3.3.3 state change from FULL to DOWN tic 100
40-33 debug ip ospf interface
This command is used to turn on the OSPF interface state debug switch. Use the no form of the command to turn off
the OSPF interface state debug switch.
debug ip ospf interface
no debug ip ospf interface
Parameters
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default OSPF debug function is turned off.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on or turn off OSPF debug function while the global debug
function has been turned on before.
This example shows how to turn on the OSPF debug function.
None.
By default, the OSPF neighbor state debug switch is turned off.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on or turn off OSPF neighbor state debug switch. When
neighbor state changes or some events happen to change neighbor state, debug
information will print if OSPF debug function is turned on.
Use the command debug ip ospf to turn on the OSPF debug function.
This example shows how to turn on the OSPF neighbor state debug switch.
None.
407