Show Lldp Local Interface - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show lldp interface tenGigabitEthernet 1/0/1
Interface ID
-----------------------------------------------------------------
Admin Status
Notification Status
Advertised TLVs Option
Port Description
System Name
System Description
System Capabilities
Enabled Management Address
(None)
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol_Identity
(None)
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
DXS-3600-32S#

32-18 show lldp local interface

This command is used to display the LLDP of each physical interface information currently available for populating
outbound LLDP advertisements.
show lldp local interface interface-id [, | -] {brief | normal | detail}
Parameters
interface interface-id
,
-
brief
normal
detailed
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows the output from the show lldp interface command. To display a
specific physical interface configuration.
: 1/0/1
: TX_and_RX
: Disabled
:
Specifies the valid physical interface.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specifies a range of interfaces. No space before and after the hyphen.
Displays the information in brief mode.
Displays the information in normal mode. This is the default display mode.
Displays the information in detailed mode.
None.
User EXEC Mode.
Level: 3
This command displays the LLDP of each physical interface information currently
available for populating outbound LLDP advertisements.
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
321