D-Link DXS-3600-16S Manual page 524

no router rip
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config-router)#
52-13 show ip rip
This command is used to show the RIP information.
show ip rip [vrf vrf-name]
Parameters
vrf vrf-name
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, RIP is disabled.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
This command is used to enable the RIP and enter the Router configuration mode of
RIP protocol. The no form of this command will disable RIP function.
You can verify your settings by entering the show ip rip command.
This example shows how to enable RIP and enter the RIP router configuration
mode.
(Optional) Specifies to display information about the RIP VRF instance.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
This command is used to show the settings about RIP timers, status, redistribution,
and interface RIP version, authentication, and status.
516