D-Link DXS-3600-16S Manual page 469

Display Parameters
BSR Priority
Role
Priority
Hash mask length
state
Next
Cand_RP_advertisement in
Next bootstrap message in
Holdtime
Candidate RP
47-16 show ip pim sparse-mode interface
This command is used to display PIM-SM interface information.
show ip pim sparse-mode interface [IFNAME [detail]]
Parameters
IFNAME
detail
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip pim sparse-mode interface
IP Address Interface
---------------- ------------ ----- -------- ----------
10.90.90.90 vlan1
172.18.63.1 vlan2
Total Entries: 2
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
Priority as configured in the ip pim bsr-candidate command.
The role of our CBSR.
Priority of our CBSR.
Length of a mask (32 bits maximum) that is to be ANDed with the group address
before the hash function is called. This value is configured in the ip pim bsr-
candidate command.
State of this switch (elected or not).
Time in hours, minutes, and seconds in which the next candidate rendezvous-point
advertisement will be sent.
Time in hours, minutes, and seconds in which the next bootstrap message is due
from this BSR.
The hold time of the candidate RP, this value is configured by ip pim rp-candidate
Candidate RP information of this switch.
Specifies the interface to display the neighbor. If no IFNAME specified, all interface's
neighbor would be displayed.
Displayd the detail information of interface.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
Use to display PIM-SM interface information.
This example shows all PIM-SM interface information.
Mode state
SM Enabled
SM Enabled
Nbr count
1
2
461