D-Link DXS-3600-16S Manual page 227

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip dhcp server
DHCP Service : Disabled
Ping Packets : 2
Ping Timeout : 500 ms
DXS-3600-32S#
Display Parameters
DHCP Service
Ping Packets
Ping Timeout
14-24 vrf
This command is used to associate the on-demand address pool with a VPN routing and forwarding instance (VRF)
name. To remove the VRF name, use the no form of this command.
vrf vrf-name
no vrf vrf-name
Parameters
vrf vrf-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# ip dhcp pool pool1
DXS-3600-32S(dhcp-config)# vrf pool1
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Privileged Mode.
Level: 2
This command displays the status of the DHCP server.
This example is used to display the DHCP server status:
Description
The status of DHCP service.
Number of packets the ping operation will send.
The timeout that the DHCP server waits for response.
Specifies the name of the VRF to which the address pool is associated.
None.
DHCP Address Pool Configuration Mode.
Level: 2
Associating a pool with a VRF allows overlapping addresses with other pools that
are not on the same VRF. Only one pool can be associated with each VRF.
This example associates the on-demand address pool with a VRF named pool1:
219