D-Link DXS-3600-16S Manual page 459

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim join-prune-interval 1000
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim join-prune-interval
DXS-3600-32S(config)#
47-4 ip pim dr-priority
This command is used to configure the priority for which a switch is elected as the designated router (DR). To return
default, use the no form of this command.
ip pim dr-priority PRIORITY
no ip pim dr-priority
Parameters
PRIORITY
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip pim dr-priority 100
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 2
DXS-3600-32S(config-if)#no ip pim dr-priority
DXS-3600-32S(config-if)#
47-5 ip pim register-suppression
This command is used to configure the register suppression time. To return to the default interval, use the no form of
this command.
ip pim register-suppression SECONDS
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the PIM join/prune interval to 1000 seconds.
This example shows how to configure the PIM join/prune interval back to default.
Specifies that the larger the value is, the higher the priority will be. The range is 0 to
4294967294.
The default value is 1.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The switch with the biggest priority would be selected as DR on a LAN. If several
switches have the same
DR priority, the one with the highest IP address would be selected. If the DR priority
field is not set in PIM hello messages, the one with highest IP address is selected to
be DR.
To verify your configuration, use show ip pim sparse-mode interface detail.
This example shows how to configure the priority of VLAN 1 to be 100.
This example shows how to configure DR priority of VLAN 2 back to default.
451