D-Link DXS-3600-16S Manual page 626

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#mtu 1000
DXS-3600-32S(config-vpls)#
67-5 peer
This command is used to create a peer in a VPLS. Use the no peer command to delete a peer in a VPLS.
peer IP-ADDRESS [VC-ID] [{network | spoke}]
no peer IP-ADDRESS [VC-ID]
Parameters
IP-ADDRESS
VC-ID
network
spoke
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#peer 2.2.2.2
DXS-3600-32S(config-vpls)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#peer 2.2.2.2 100 spoke
DXS-3600-32S(config-vpls)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command is used to set the local AC link MTU of a VPLS in VPLS configuration
mode. The local AC link MTU of a VPLS can be modified only when there is no
pseudowire in this VPLS.
This example shows how to set the local AC link MTU of a VPLS to 1000.
Specifies the LSR ID that is used to identify the PE.
(Optional) Specifies the pseudowire ID. This ID must be between 1 and 4294967295.
It is used with the IP-ADDRESS to uniquely identify a peer for a VPLS. If no ID is
specified, the pseudowire ID is configured to be the same as the VPLS ID of this
VPLS.
Specifies that a peer is used as a network pseudowire. The packets from other
network pseudowires in a VPLS must not be forwarded to this pseudowire and the
packets from this pseudowire must not be forwarded to other network pseudowires in
the VPLS. It is the "split horizon" rule.
Specifies that a peer is used as a spoke pseudowire (in H-VPLS topology). The
packets from other pseudowires in a VPLS can be forwarded to this pseudowire, and
the packets from this pseudowire can be forwarded to other pseudowires in the
VPLS.
The VC-ID is configured to be the same as the VPLS ID of this VPLS and it is a
network pseudowire.
VPLS Configuration Mode.
Level: 15.
This command is used to create a peer in a VPLS. The no peer command is used to
delete a peer or a backup peer from a VPLS.
This example shows how to create a peer, with the IP address of 2.2.2.2. The VC ID
is set by the VPLS ID and it is a network pseudowire.
This example shows how to create a peer, with the IP address of 2.2.2.2. The VC ID
is 100 and it is a spoke pseudowire in the H-VPLS topology.
618