D-Link DXS-3600-16S Manual page 320

lldp reinit-delay seconds
no lldp reinit-delay
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lldp reinit-delay 5
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no lldp reinit-delay
DXS-3600-32S(config)#
32-7 lldp notification-interval
This command is used to set the the timer of the notification interval for sending notifications to configured SNMP trap
receiver(s). Use the no form of this command to return to the default settings.
lldp notification-interval seconds
no lldp notification-interval
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lldp notification-interval 10
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no lldp notification-interval
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies a delay for LLDP initialization on an interface. Valid values are from 1 to 10
seconds.
2 seconds.
Global Configuration Mode.
Level: 12
A re-enabled LLDP physical interface will wait for reinit-delay after last disable
command before reinitializing.
This example shows how to set the re-init delay interval to 5 seconds.
This example shows how to set the re-init delay interval to default value.
Specifies the timer of the notification interval for sending notifications to configured
SNMP trap receiver(s). Valid values are from 5 to 3600 seconds.
5 seconds.
Global Configuration Mode.
Level: 12
Globally change the interval between successive LLDP change notifications
generated by the switch.
This example shows how to set the notification interval to 10 seconds.
This example shows how to set the notification interval to default value.
312