Show Interface - D-Link DXS-3600-16S Manual

Parameters
64-12288
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#mtu 1234
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no mtu
DXS-3600-32S(config-if-range)#
43-9 snmp trap link-status
This command is used to specify the SNMP trap-link status.
snmp trap link-status
no snmp trap link-status
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#snmp trap link-status
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no snmp trap link-status
DXS-3600-32S(config-if-range)#

43-10 show interface

This command is used to display interface information.
show interface [{tenGigabitEthernet <portlist>}] [{description | status | switchport}]
Parameters
portlist
description
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to set the Maximum Transmission Unit value. This value must be between
64 and 12288.
The default MTU value is 1536.
Port Configuration Mode.
Level: 15
This command is used to specify the Maximum Transmission Unit (MTU) of the port.
This example shows how to specify the Maximum Transmission Unit (MTU) of the
port.
None.
By default, this option is enabled.
Port Configuration Mode.
Level: 15
To set the port interface send trap when port interface link changes. The no form, of
this command, means not to send traps when a port interface link changes.
This example shows how to specify the SNMP trap-link status.
Specifies the range of ports that will be displayed.
Specifies the interface description, including the link status.
425