Show Lldp - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no lldp dot3-tlv-select mac-phy-config-status
DXS-3600-32S(config-if)#

32-15 show lldp

This command is used to display the switch's general LLDP configuration status.
show lldp
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message TX Interval
Message TX Hold Multiplier: 4
ReInit Delay
TX Delay
Notification Interval
DXS-3600-32S#
32-16 show lldp management-address
This command is used to display the LLDP management address information.
show lldp management-address [ipv4 ip-address]
Parameters
ipv4 ip-address
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to disable MAC/PHY Configuration/Status TLV
advertisement.
None.
None.
User EXEC Mode.
Level: 3
Used to show LLDP system global configurations.
This example shows how to display the LLDP system global configuration status.
: MAC Address
: 00-01-02-03-04-00
:
: TenGigabit Ethernet Switch
: Repeater, Bridge
: Disabled
: Disabled
: 30
: 2
: 2
: 5
Specifies the IPv4 address used.
None.
User EXEC Mode.
Level: 3
This command is used to display the LLDP management address information.
319