D-Link DXS-3600-16S Manual page 594

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#logging server 10.90.90.4
DXS-3600-32S(config)#logging trap 6
DXS-3600-32S(config)#
60-5 logging source
This command is used to configure the source IP address of logs. The no format of the command cancel the specified
source's configuration.
logging source {interface INTERFACE-ID | IP-ADDRESS}
no logging source
Parameters
interface INTERFACE-ID
IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#logging source interface vlan 1
DXS-3600-32S(config)#
60-6 logging facility
This command is used to configure the log device. The no format of the command restores it to the default device
value.
logging facility FACILITY-TYPE
no logging facility
Parameters
FACILITY-TYPE
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
To send logs to the syslog server, execute first the global configuration command
logging server to configure syslog server. Then, execute logging trap to specify the
severity of logs to be sent. The show logging command displays the related setting
parameters and statistics of the log.
This example shows how to enable logs at severity 6 to be sent to the syslog server
at address 10.90.90.4
Specifies the interface which IP address that will be used as source to send logs to
log server
Specifies the source IPV4 address that will be used as source to send logs to log
server.
None.
Global Configuration Mode.
Level: 15
By default, the source address of the log messages sent to the syslog server is the
address of the sending interface. For easy tracing and management, this command
can be used to fix the source address of all log messages as an interface address,
so that the administrator can identify which device is sending the message through
the unique addresses.
This example shows how to specify VLAN 1 as the source interface of the syslog
messages.
Specifies the Syslog device value.
586