D-Link DXS-3600-16S Manual page 359

Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls ldp targeted-peer 110.10.10.1
DXS-3600-32S(config-mpls-targeted-peer)# target-hello holdtime 90
DXS-3600-32S(config-mpls-targeted-peer)#
38-15 ldp router-id
This command is used to set the LSR ID of the LDP. Use no ldp router-id command to restore the LSR ID to default
value.
ldp router-id IP-ADDRESS
no ldp router-id
Parameters
IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls label protocol ldp
DXS-3600-32S(config-mpls-router)# ldp router-id 110.10.10.30
DXS-3600-32S(config-mpls-router)#
38-16 transport-address
This command is used to set the global transport address. Use the no form of this command to restore the default
value.
transport-address {interface | IP-ADDRESS}
no transport-address
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
MPLS Targeted Peer Configuration Mode.
Level: 15.
It is necessary to ensure that the hold-time of the target hello is larger than the
interval value. Otherwise, LDP can not work normally according to the requirement.
This example shows how to configure the LDP extended discovery hello hold time to
90 seconds for targeted peer 110.10.10.1.
Specifies the IPv4 address that will be used as LSR ID. The IPv4 address must be
an IP address of an existing interface.
The LSR ID will be selected according the following rules:
1 If a loopback interface is configured, the LSR ID is set to the IP address of the
loopback interface. If multiple loopback interfaces are configured, the loopback
with the highest IP address will be used.
2 If no loopback interface is configured, the LSR ID is set to the highest IP address
of the link-up interfaces.
3 If no interface is link-up, the LSR ID is set to the highest IP address of the
interfaces.
Note: If LDP is running, LSR ID will not be auto-changed.
MPLS Router Configuration Mode.
Level: 15.
The LSR ID is used to identify the LSR in the MPLS network. It is recommended to
set the LSR ID to the IP address of a loopback interface. The value of the LSR ID
should be globally unique. By default, the LSR ID is used as the transport-address. It
is necessary to ensure that the LSR ID is route reachable for other LSRs. Note: If
LDP is running, configuring the LSR ID will lead to an LDP restart.
This example shows how to configure the LDP LSR ID to 110.10.10.30.
351