D-Link DXS-3600-16S Manual page 617

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#acceptable-frame tagged-only
DXS-3600-32S(config-if)#
66-9 ingress-checking
This command is used to enable the ingress checking of the received frames on a port. Use the no ingress-checking
interface command to disable the ingress checking function.
ingress-checking
no ingress-checking
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#ingress-checking
DXS-3600-32S(config-if)#
66-10 mac-base (vlan)
This command is used to create a MAC-based VLAN classification entry. Use the no mac-base command to remove a
MAC-based VLAN classification entry.
mac-base MAC-ADDRESS [priority COS-VALUE]
no mac-base MAC-ADDRESS
Parameters
MAC-ADDRESS
priority COS-VALUE
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
In the following example, the user sets the acceptable frame type to be tagged-only
on port 1.
None.
By default, ingress checking is enabled.
Interface Configuration Mode.
Level: 12
The valid interfaces for this command are physical ports or link aggregation groups.
You can use the ingress-checking interface command to enable ingress checking
on interfaces. If ingress checking is enabled, if the port is not member port of the
VLAN that has been classified for the received packet, the packet will be dropped.
The user can use the no ingress-checking interface command to disable this
function on a port.
This example shows how to set ingress checking to enable of port 1.
Specifies the MAC address for the entry.
Specifies the priority for the entry. The value is a number from 0 to 7, if the priority is
not specified, the default value is 0.
No MAC-based VLAN ID classification entries exist.
VLAN Configuration Mode.
Level: 12
609