D-Link DXS-3600-16S Manual page 42

Example
DXS-3600-32S#show access-group
Interface tenGigabitEthernet 1/0/2:
ipv6 access-group ipv6-11 in
ipv6 access-group ipv6-1 out
expert access-group exp1 in
Interface tenGigabitEthernet 1/0/11:
ip access-group 11 in
ip access-group std-ip-1 out
mac access-group 6005 in
mac access-group ext-mac-6000 out
DXS-3600-32S#
3-19 show ip access-group
This command is used to display the IP ACL configuration of the interface.
show ip access-group [interface interface]
Parameters
interface interface
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip access-group
Interface tenGigabitEthernet 1/0/11:
ip access-group 11 in
ip access-group std-ip-1 out
DXS-3600-32S#
3-20 show ipv6 access-group
This command is used to display the IPv6 ACL configuration of the interface.
show ipv6 traffic-filter [interface interface]
Parameters
interface interface
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display the ACL, applied to the interface.
Specifies the interface ID used.
None.
EXEC Mode.
Level: 1
Displays the IP ACL applied to the interface. If no interface is specified, the IP ACLs
applied to all the interfaces will be displayed.
This example shows how to display the IP ACL, applied to the interface.
Specifies the interface ID used.
None.
EXEC Mode.
Level: 1
Displays the IPv6 ACL applied to the interface. If no interface is specified, the IPv6
ACLs applied to all the interfaces will be displayed.
34