D-Link DXS-3600-16S Manual page 631

Example
DXS-3600-32S#show vpls vpls102 detail
VPLS Name: vpls102, Operate Status: Up
VPLS ID: 102, Service Type: Tagged, MTU: 1500
Peers via Pseudowires:
VC ID Peer
---------- ---------------
100 1.1.1.1
100 2.2.2.2
Local ACs:
Local AC
-----------------
Eth1/0/17/VLAN102
Total Entries: 1
DXS-3600-32S#
67-9 show mac-address-table vpls
This command is used to display VPLS MAC address information.
show mac-address-table vpls [VPLS-NAME [{peer IP-ADDRESS [VC-ID] | ac interface INTERFACE-ID [vlan
VLAN-ID]}]] [address MAC-ADDR]
Parameters
VPLS-NAME
peer
IP-ADDRESS
VC-ID
ac
interface INTERFACE-ID
vlan VLAN-ID
address MAC-ADDR
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display detailed information for a VPLS with PW
redundancy.
Type
-------
Primary
Backup
Oper Status
-----------
Up
(Optional) Specifies the VPLS name. This name can be up to 32 characters long.
(Optional) Specifies a peer in a VPLS.
(Optional) Specifies the LSR ID that is used to identify the PE which the peer is
belongs to.
(Optional) Specifies the pseudowire ID. This ID must be between 1 and 4294967295.
(Optional) Specifies a local AC in a VPLS.
(Optional) Specifies the Ethernet interface of a local AC.
(Optional) Specifies that a local AC is an Ethernet VLAN-based AC and the related
VLAN ID. If not specified, the local AC will be an Ethernet-based AC.
(Optional) Specifies to display the MAC address.
None.
EXEC Mode.
Level: 3.
This command is used to display VPLS MAC address information. A user can select
to display a specified VPLS MAC address, or the VPLS MAC addresses on a
specified VPLS peer, or the VPLS MAC addresses on a specified VPLS AC, or the
VPLS MAC addresses on a specified VPLS, or all VPLS MAC addresses.
Oper Status
-----------
Up
Standby
623