Protocol Independent Multicast (Pim) Commands - D-Link DXS-3600-16S Manual

Protocol Independent Multicast (PIM) Commands

47-1 ip pim
This command is used to enable Protocol Independent Multicast (PIM) on an interface. To disable PIM on the interface,
use the no form of this command.
ip pim {dense-mode | sparse-mode | sparse-dense-mode}
no ip pim
Parameters
dense-mode
sparse-mode
sparse-dense-mode
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip pim dense-mode
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no ip pim
DXS-3600-32S(config-if)#
47-2 ip pim query-interval
This command is used to configure the frequency of Protocol Independent Multicast (PIM) router query messages. To
return to the default interval, use the no form of this command.
ip pim query-interval SECONDS
no ip pim query-interval
Parameters
SECONDS
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to enables dense mode of operation.
Specifies to enables sparse mode of operation.
Specifies to enables sparse-dense-mode of operation.
PIM is disabled on all interfaces.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command enables PIM protocol on the specified interface. An interface can be
configured to be in dense mode, sparse mode or sparse-dense mode.
If you want to use PIM to forward multicast packets, use ip multicast-routing
command to enable multicast global state.
To verify your configuration, use show ip pim sparse-mode interface or show ip
pim dense-mode interface.
This example shows how to configure the interface VLAN 1 to enable PIM dense-
mode.
This example shows how to disable PIM on interface VLAN 1.
Specifies the interval of sending hello message, in the range of 1 to 18724 seconds.
30 seconds.
449