Debug Ip Bgp Show Neighbors - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#debug ip bgp show global
Following is the information for global debugging:
---------------------------------------------------
AS Number
Router ID
Cluster ID
Confed ID
Confederation peers
Fast External Fallover
Dampening Ability
Client to Client Ability
Cluster Peers
Aggregate Next_Hop_Check
Default Local Preference
Default Holdtime
Default Keepalive
Scan Time
BGP Active Flags:
BGP Active AF-Flags
BGP_AF_CFLAG_NETWORK_SYNC
Note: The address family is IPv4
BGP Active Redist-Flags:
IPI_ROUTE_CONNECT
Note: The address family is IPv4
DXS-3600-32S#

7-101 debug ip bgp show neighbors

This command is used to show internal detailed information about BGP neighbors.
debug ip bgp show neighbors [{vrf VRF-NAME | vpnv4}]
Parameters
vrf VRF-NAME
vpnv4
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display detailed internal information about BGP.
: 65100
: 0.0.0.0
: 0.0.0.0
: 0
:
: Enabled
: Disabled
: Enabled
: 1.1.1.1
: Disabled
: 100
: 150
: 50
: 60
:
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
Displays the neighbor parameters in the address family of VPNv4
None.
Privileged Mode.
Level: 15. (EI Mode Only Command)
Use this command to check internal status and detailed information of BGP
neighbors.
164