D-Link DXS-3600-16S Manual page 129

Display Parameters
IP Address/Netmask
Gateway
Metric
LocPrf
Weight
Route Distinguisher
default for vrf
VPN route(s)
Path
From
In label
Out label
Self Peer
no
7-70 show ip bgp rd
This command is used to display entries in the BGP routing table in the IPv4 VPN address family with the specified
Route Distinguisher.
show ip bgp rd ASN:NN [{IP-ADDRESS | NETWORK-ADDRESS [longer-prefixes] | label}]
Parameters
ASN:NN
IP-ADDRESS
NETWORK-ADDRESS
longer-prefixes
label
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
IP prefix with its mask length of the entry.
IP address of the next router that is used when forwarding a packet to the destination
network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to
this network.
If shown, this is the value of the inter-autonomous system metric. This field is
frequently not used.
Local preference value as set with the set local-preference route-map
configuration command. The default value is 100.
Weight of the route as set via autonomous system filters.
Specify the route distinguisher of the following routes.
Specify the VRF which The route distinguisher is default for.
Specify that the following routes are learned from PEs.
Autonomous system paths to the destination network.
Specify the origin of this prefix.
Specify the label which would be assigned to other routes that origin from other PE.
Specify the label which get form other PE neighbor.
Specify that the route is originated from local.
Specify this prefix does not have label of this direction.
Specifies the Route Distinguisher.
(Optional) Specifies the IP address entered to filter the output to display only a
particular host or network in the BGP routing table.
(Optional) Specifies to display the route matching the network address.
(Optional) Displays the specified route and all more specific routes.
(Optional) Specifies to display the BGP private labels of the routes, which are
assigned from MPLS.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
This command is used to display BGP route information in the VPNv4 address family
and VRF address family based on Route Distinguisher.
121