D-Link DXS-3600-16S Manual page 567

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree tx-hold-count 5
Success
DXS-3600-32S(config)#
57-5 spanning-tree max-hops
This command is used to configure the MSTP related max-hops timers. Use the no form of this command to return the
setting to default setting.
spanning-tree max-hops MAX-COUNT
no spanning-tree max-hops
Parameters
MAX-COUNT
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree
Success
DXS-3600-32S(config)#
57-6 spanning-tree mode
This command is used to decide the STP mode. To return to the default settings, use the no form of this command.
spanning-tree mode {mstp | rstp |stp}
no spanning-tree mode
Parameters
mstp
rstp
stp
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 8
This parameter will be commonly used by STP, RSTP, and MSTP.
Note: Changing this parameter to a higher value may have a significant impact on
CPU utilization, especially in MSTP mode. Lowering this parameter could slow
convergence in some scenarios. We recommend that you do not change the value
from the default setting.
This example shows how to configure the tx-hold-count value.
Specifies the MSTP maximum hop number. The range is 6 to 40 hops.
The default value is 20.
Global Configuration Mode.
Level: 8
Use this command to configure the MSTP related max-hops timers.
This example shows how to configure the max-hops value.
max-hops 19
Specifies to used the Multiple Spanning Tree Protocol (MSTP).
Specifies to used the Rapid Spanning Tree Protocol (RSTP).
Specifies to used the Spanning Tree Protocol (IEEE 802.1D-Compatible)
559