D-Link DXS-3600-16S Manual page 293

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip access-list standard IPS
DXS-3600-32S(config-std-nacl)#deny 121.2.0.0/8
DXS-3600-32S(config-std-nacl)#deny 126.1.2.2/8
DXS-3600-32S(config-std-nacl)#
26-3 permit
This command is used to set the permit rules of standard IP access list. Use the no form of this command to remove
the permit rules.
permit NETWORK-ADDRESS
no permit NETWORK-ADDRESS
Parameters
NETWORK-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip access-list standard IPS
DXS-3600-32S(config-std-nacl)#permit 120.2.0.0/8
DXS-3600-32S(config-std-nacl)#permit 125.1.2.2/8
DXS-3600-32S(config-std-nacl)#
26-4 show ip standard access-list
This command is used to display the access-list configuration.
show ip standard access-list [ACCESS-LIST-NAME]
Parameters
ACCESS-LIST-NAME
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure deny rules for a standard IP access list.
Specifies a specific network address.
None.
Access List Configuration Mode.
Level: 8
One or multiple permit rules can be added to the list.
Users can verify the settings by entering the show ip standard access-list
command.
This example shows how to configure permit rules for a standard IP access list.
(Optional) Displays information about one specified standard IP access list.
None.
Privileged EXEC Mode.
Level: 3
If no parameter is specified, then information about all standard IP access lists will be
displayed.
285