Lldp-Dcbx Commands - D-Link DXS-3600-16S Manual

LLDP-DCBX Commands

33-1 lldp-dcbx run
This command is used to to enable the Data Center Bridging eXchange Protocol (DCBX) on each physical interface.
Use the no form of this command to return to the default settings.
lldp-dcbx run
no lldp-dcbx run
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)# lldp-dcbx run
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)# no lldp-dcbx run
33-2 lldp-dcbx tlv-select
This command is used to specify which optional type-length-value settings (TLVs) in the LLDP DCBX management set
will be transmitted and encapsulated in the LLDPDUs and sent to neighbor devices. To disable transmit the TLVs, use
the no form of this command.
lldp-dcbx tlv-select [ets-configuration | ets-recommendation | pfc-configuration]
no lldp-dcbx tlv-select [ets-configuration | ets-recommendation | pfc-configuration]
Parameters
ets-configuration
ets-recommendation
pfc-configuration
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Enabled.
Interface Configuration Mode.
Level: 12.
This is the control for the LLDP DCBX function on each physical interface for
exchanging LLDP DCBX TLVs.
This example shows how to enable the LLDP DCBX setting.
This example shows how to disable the LLDP DCBX setting.
Specifies the ETS Configuration TLV to send or receive. This TLV allows network
management to advertise the allocation of bandwidth to traffic classes of user's
configuration.
Specifies the ETS Recommendation TLV to send or receive. This TLV allows
network management to advertise the allocation of bandwidth to traffic classes of
user's recommendation.
Specifies the Priority-based Flow Control Configuration TLV to send or receive. This
TLV allows network management to advertise the PFC configuration.
No LLDP DCBX management TLV is selected.
Interface Configuration Mode.
Level: 12.
This command specifies the optional TLVs advertisement settings. If the optional
TLVs advertisement state enabled, they will be encapsulated in LLDPDU and sent to
other devices.
327