Show Ip Ospf Interface - D-Link DXS-3600-16S Manual

40-27 show ip ospf interface

This command is used to display interface information for OSPF.
show ip ospf interface [ipif_name] [vrf vrf-name]
Parameters
ipif_name
vrf vrf-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip ospf interface
Interface Name: vlan1
Network Medium Type: Broadcast
Area ID: 0.0.0.0
Priority: 50
DR Address: None
Hello Interval: 10
Transmit Delay: 1
Authentication: MD5
Passive Mode: Enabled
DXS-3600-32S#
Example
DXS-3600-32S#show ip ospf interface System
Interface Name: System
Network Medium Type: BROADCAST
Area ID: 0.0.0.0
Priority: 1
DR Address: 10.1.1.2
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Passive Mode: Disabled
DXS-3600-32S#
Display Parameters
Interface Name
IP Address
Network Medium Type
Metric
Area ID
Administrative State
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies the interface name to display the OSPF information.
(Optional) Specifies to show interface information about the OSPF VRF instance.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
Use this command to check OSPF interface settings.
This example shows information of all OSPF interfaces.
IP Address: 0.0.0.0/0 (Link Down)
Metric: 2
Administrative State: Disabled
DR State: Down
Backup DR Address: None
Dead Interval: 60
Retransmit Time: 5
MD5 Key ID for Authentication: 10
This example shows information of System interfaces.
IP Address: 10.1.1.1/24 (Link Up)
Metric: 1
Administrative State: Enabled
DR State: BDR
Backup DR Address: 10.1.1.1
Dead Interval: 40
Retransmit Time: 5
Description
Name of the interface.
IP address of the source used to send out OSPF packet to neighbor.
The type of OSPF network.
OSPF interface cost. It is specified with the command ip ospf cost.
The area this interface belongs to. It is specified with the command network area.
The administrative state of this interface. It is specified with the command network
area.
403