D-Link DXS-3600-16S Manual page 561

Example
DXS-3600-32S#show sntp
SNTP Status
SNTP poll interval
SNTP Server Status:
Stratum Version Last Receive
------- ------- --------------- ------------------------------------
5 1 00:00:12 Synced 10.0.0.2
------- ------- --------------- ------------------------------------
Total Entries: 1
DXS-3600-32S#
Display Parameters
SNTP server
Stratum
Version
Last Receive
Synced
56-5 clock set
This command is used to manually set the system clock.
clock set HH:MM:SS DDMMMYYYY
Parameters
HH:MM:SS
DDMMMYYYY
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#clock set 13:32:00 23dec2011
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to check the SNTP information.
: Enabled
: 720 sec
SNTP server
Description
IP Address of the configured NTP server.
NTP stratum of the server. The stratum indicates how far away from an authoritative
time source the server is.
NTP version of the server.
Time since the last NTP packet was received from the server.
Indicates the server chosen for synchronization.
Specifies the current time, in the format of Hour (24-hour): Minute: Second
Specifies the current date.
DD - Current day (1-31) in the month.
MMM - Current month (jan, feb, mar, apr, may, jun, jul, aug, sep, oct, nov, dec).
YYYY - Current year (2000-2100).
None.
Privileged EXEC Mode.
Level: 8
Use this command to set the system time to facilitate the management. For devices
without hardware clock, the time set by the clock set command takes effect for only
the current setting. Once the device powers off, the manually set time becomes
invalid. The time specified in this command is relative to the configured time zone.
You can verify your settings by entering the show clock command.
This example shows how to manually sets the software clock to 1:32 p.m. on
December 23, 2011.
553