D-Link DXS-3600-16S Manual page 553

55-9 snmp-server community
This command is used to set up the community access string to permit access to the SNMP. Use the no command to
remove the specified community string,
snmp-server community COMMUNITY-STRING view VIEW-NAME {ro | rw}
no snmp-server community COMMUNITY-STRING
Parameters
COMMUNITY-STRING
view VIEW-NAME
ro
rw
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server community comaccess view mib2 rw
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no snmp-server community comaccess
DXS-3600-32S(config)#
55-10 snmp-server enable traps
This command is used to enable all Simple Network Management Protocol (SNMP) notification types that are available
on your system, use the snmp-server enable traps command in global configuration mode. To disable all available
SNMP notifications, use the no form of this command.
snmp-server enable traps
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the community string that consists of from 1 to 32 alphanumeric characters
and functions much like a password, permitting access to the SNMP protocol. Blank
spaces are not permitted in the community string. The syntax is general string that
does not allow space.
(Optional) Specifies the name of a previously defined view. The view defines the
objects available to the SNMP community.
(Optional) Specifies read-only access. Authorized management stations are only
able to retrieve MIB objects.
(Optional) Specifies read-write access. Authorized management stations are able to
both retrieve and modify MIB objects.
There are two communities in the default as following:
Community Name: private
Community Index: private
Community SecurityName: private
Storage-type: nonVolatile active
Community Name: public
Community Index: public
Community SecurityName: public
Storage-type: nonVolatile active
Global Configuration Mode.
Level: 12
This command creates a community name entry in the community name table.
This example shows how to create SNMP community called 'comaccess' with view
mib2.
This example shows how to remove the SNMP community called 'comaccess'.
545