Show Monitor - D-Link DXS-3600-16S Manual

36-3 show monitor

This command is used to display monitor sessions.
show monitor [session session_number]
Parameters
session_number
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show monitor
sess-num: 1
src-intf:
TenGigabitEthernet1/0/1
TenGigabitEthernet1/0/2
TenGigabitEthernet1/0/3
dest-intf:
TenGigabitEthernet1/0/9
acl-name: mac_based_mirr
sess-num: 2
src-intf:
TenGigabitEthernet1/0/5
dest-intf:
TenGigabitEthernet1/0/21 / port-group 1
acl-name:
DXS-3600-32S#
Display Parameters
sess-num
src-intf
frame-type
dest-intf
acl-name
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the mirror session number to display.
All the monitor sessions are displayed.
Privileged EXEC Mode.
Level: 3
The command can be used to display mirror sessions. All monitor sessions are
displayed if you do not specify the session number.
This example shows how to display all the mirror sessions.
frame-type
frame-type
frame-type
frame-type
Description
Mirror session number, the range is from 1 to 4.
The source port list of mirror session.
The mode of mirrored traffic, such as RX, TX and both.
The destination port of mirror session. If it is a trunk member, the trunk group id will
be also displayed.
The ACL name of flow_based mirror.
Both
Both
Both
RX
340