D-Link DXS-3600-16S Manual page 668

73-3 random-detect exponential-weight
This command is used to configure the WRED exponential weight factor for the average queue size calculation for the
queue. The no form is used to configure it to the default setting.
random-detect exponential-weight COS-VALUE exponent <VALUE 0-15>
no random-detect exponential-weight
Parameters
COS-VALUE
exponent <VALUE 0-15>
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/3
DXS-3600-32S(config-if)#random-detect exponential-weight 5 exponent 10
Success
DXS-3600-32S(config-if)#
73-4 random-detect profile
This command is used to configure the WRED profile. Use no form of this command to configure it to default setting.
random-detect profile id [tcp | non-tcp] [green | yellow | red] min-threshold <0-100> max-threshold <0-100>
max-drop-rate <0-14>
no random-detect profile id
Parameters
id
tcp
non-tcp
green
yellow
red
min-threshold <0-100>
max-threshold <0-100>
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the CoS queues on which exponent will be set.
Specifies the exponent value used in the average queue size calculation. This value
must be between 0 and 15.
The default exponential weight factor is 9.
Interface Configuration Mode.
Level: 15
Only physical ports are valid for this command.
This example shows how to configure the exponent to 10 and the queue to 5.
Specifies the ID of the WRED profile that will be set.
Specifies the WRED drop parameters for TCP packet to be set. If not specified, the
same WRED drop parameter will be set for both type of traffic.
Specifies the WRED drop parameters for a Non-TCP packet to be set. If not
specified, the same WRED drop parameter will be set for both type of traffic.
Specifies the WRED drop parameters for the green packet to be set. If not specified,
the same WRED drop parameter will be set for all color packet.
Specifies the WRED drop parameters for the yellow packet to be set. If not specified,
the same WRED drop parameter will be set for all color packet.
Specifies the WRED drop parameters for the red packet to be set. If not specified,
the same WRED drop parameter will be set for all color packet.
Specifies the minimum queue size (in percentage of total queue size) to start WRED
dropping. This value must be between 0 and 100.
Specifies the maximum queue size (in percentage of total queue size) over which
WRED will drop all packets destined for this queue. This value must be between 0
and 100.
660