D-Link DXS-3600-16S Manual page 87

prefix-filter
out
soft
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#clear ip bgp 10.100.0.1 soft in
DXS-3600-32S#
Example
DXS-3600-32S#clear ip bgp 172.16.10.2 soft in prefix-filter
DXS-3600-32S#
Example
DXS-3600-32S#clear ip bgp 35700
DXS-3600-32S#
7-23 clear ip bgp vrf
This command is used to reset BGP connections using hard or soft reset for IPv4 VRF address family sessions.
clear ip bgp vrf VRF-NAME {all | IP-ADDRESS | AS-NUMBER} [soft [{in [prefix-filter] | out}]]
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies to clear the existing outbound route filter (ORF) prefix list to
trigger a new route refresh or soft reconfiguration, which updates the ORF prefix list.
(Optional) Specifies to initiate inbound or outbound reconfiguration. If neither the in
nor the out keywords are specified, both inbound and outbound sessions will reset.
(Optional) Specifies to initiate a soft reset. Does not tear down the session.
None.
Privileged Mode.
Level: 8. (EI Mode Only Command)
This command can be used to initiate a hard reset or soft reconfiguration of BGP
neighbor sessions.
If a hard reset is applied to the inbound session, the inbound session will be torn
down and the local inbound routing table and the remote outbound routing table will
be cleared.
If a soft reset is applied to the inbound session, the session will not be rebuilt but the
local inbound routing table will be cleared and needs to be rebuilt.
If a soft reconfiguration inbound is enabled, then the routing table can be rebuilt
based on the stored route update information. If a soft reconfiguration inbound is
disabled, then the local router will send a route refresh request to the neighbor to ask
for the route refresh.
When the inbound session undergoes a soft reset with the prefix filter option, and the
capability of the prefix-list is enabled, in the sending direction, then the local BGP will
send a 'clear the routing table' request, and notify the remote neighbor for the prefix
filter.
This is a way to notify the neighbor of the prefix filter whenever a change is made to
the prefix filter.
In the following example, a soft reconfiguration is initiated for the inbound session
with the neighbor 10.100.0.1, and the outbound session is unaffected.
In the following example, the route refresh capability is enabled on BGP neighbor
routers. The existing outbound route filter (ORF) prefix list from the peer 172.16.10.2
is cleared, The new route refresh, which updates the ORF prefix list, is triggered.
In the following example, a hard reset is initiated for sessions with all routers in the
autonomous system numbered 35700.
79