D-Link DXS-3600-16S Manual page 304

Usage Guideline
Example
DXS-3600-32S#show ip mroute summary
IP Multicast Routing Table: 2 entries
Flags: D - Dense, S - Sparse, V - DVMRP
Timers: Uptime/Expires
(10.10.1.52, 224.0.1.3), vlan1, 00:01:32/00:03:20, Flags: D
(20.1.1.1, 228.10.2.1), vlan10, 00:05:10/00:03:11, Flags: S
DXS-3600-32S#
Example
DXS-3600-32S#show ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, V - DVMRP, s - SSM Group, F - Register flag
P - Pruned, R - (S, G) RPT-bit set, T - SPT-bit set
Outgoing interface flags: W - Assert winner
Timers: Uptime/Expires
(10.71.57.210, 235.0.0.4), 00:02:53/00:00:37, flags: ST
Incoming interface: vlan1, RPF Neighbor 1.2.0.1
Outgoing interface List:
vlan3, Forwarding 00:00:04/00:04:20
(20.2.2.10, 239.0.0.5), 00:02:53/00:00:37, flags: VP
Incoming interface: vlan20, RPF Neighbor 2.3.0.1
Outgoing interface List: NULL
(30.9.7.4, 237.0.0.6), 00:02:53/00:00:37, flags: D
Incoming interface: vlan30, RPF Neighbor 6.2.3.2
Outgoing interface List:
vlan5, Forwarding 00:01:21/00:02:39
Total Entries: 3
DXS-3600-32S#
Example
DXS-3600-32S#show ip mroute sparse
(10.1.57.1, 235.0.0.0), 00:00:04/00:03:26, flags: ST
Incoming interface: vlan1, RPF Neighbor NULL
Outgoing interface list:
vlan4, Forwarding 00:00:04/00:04:20
Total Entries: 1
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command is used to display the multicast routing entries learned on the switch
or the multicast static routes created on the switch. You can specify the parameter to
display the information that you concerning. If no parameter is specified, all IP
multicast routing entries learned on the switch will be displayed.
This example shows how to display multicast route brief information.
This example shows how to display all IP multicast routing information on the
system.
This example shows how to display IP multicast routing information learned by PIM
sparse mode.
296