Set Metric - D-Link DXS-3600-16S Manual

Parameters
NUMBER
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip standard access-list Strict-Control
DXS-3600-32S(config-ip-acl)#permit 120.1.1.0/24
DXS-3600-32S(config-ip-acl)#exit
DXS-3600-32S(config)#route-map mapprefer permit 10
DXS-3600-32S(config-route-map)#match ip address Strict-Control
DXS-3600-32S(config-route-map)#set local-preference 500
DXS-3600-32S(config-route-map)#

53-16 set metric

This command is used to add a set command to modify the metric of routes. Use the no form of this command to delete
this command.
set metric NUMBER
no set metric
Parameters
NUMBER
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the value of local preference. The range is 0 to 4294967295.
The default value of local preference is 100.
Route Map Configuration Mode.
Level: 8
Use this command to modify the local preference attribute of route when match
conditions are met.
By default, the BGP router will send the default local preference with the routes to
IBGP neighbors and to EBGP neighbors which are in one confederation. It can be
overwritten by the local preference set by the route map. For the received route, the
local preference sent with the route will be used in the best path selection. This local
preference will be overwritten if the local preference is ingress set by the route map.
For the connected routes, the default local preference will be used for them in the
best path selection.
This will take effect for both ingress and egress directions.
You can verify your settings by entering the show route-map command.
This example shows how to add a set command to modify the local preference of
route 120.1.1.0/24.
Specifies the metric of routes. The range is 0 to 4294967294.
None.
Route Map Configuration Mode.
Level: 8
Use this command to modify the metric of routes to be redistributed
.
You can verify your settings by entering the show route-map command.
532