D-Link DXS-3600-16S Manual page 401

Parameters
default
interface ipif_name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router ospf
DXS-3600-32S(config-router)#passive-interface default
DXS-3600-32S(config-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router ospf
DXS-3600-32S(config-router)#passive-interface interface System
DXS-3600-32S(config-router)#
40-21 redistribute
This command is used to redistribute external routing information into the OSPF routing domain. Use no command to
disable redistribution.
redistribute {connected | static | rip | bgp} [metric metric | metric-type {1 | 2} | route-map map-name]
no redistribute {connected | static | rip | bgp} [metric metric | metric-type {1 | 2} | route-map map-name]
Parameters
connected
static
rip
bgp
metric metric
metric-type {1 | 2}
route-map map-name
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies all the interfaces as passive interfaces.
Specifies the interface with this name as passive interface.
By default, no interface is configured as passive interface.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
If an interface is passive, the OSPF protocol packets are neither sent nor received
through the specified interface.
Users can verify the settings by entering the show ip ospf interface command.
This example shows how to set all the interfaces to be passive.
This example shows how to set the System interface to be passive.
Specifies to redistribute connected routes to OSPF.
Specifies to redistribute static routes to OSPF.
Specifies to redistribute rip routes to OSPF.
Specifies to redistribute bgp routes to OSPF.
(Optional) Specifies the metric for the redistributed routes. The value range is 0-
16777214. If it is not specified or specified as 0, the redistributed routes will be
associated with the metric as specified with the command default-metric.
(Optional) Allows the selection of one of two methods for calculating the metric
value.
1 - Calculates the metric (for other routing protocols to OSPF) by adding the
destination's interface cost to the metric entered in the Metric field.
2 - Uses the metric entered in the Metric field without change. If the metric type is
not specified, it will be type 2.
(Optional) Specifies a route map which will be used as the criteria to determine
whether to redistribute specific routes. This map-name can be up to 16 characters
long.
393