D-Link DXS-3600-16S Manual page 303

29-2 ip multicast-routing
This command is used to enable global IP multicast routing. The no form of the command disables global IP multicast
routing.
ip multicast-routing
no ip multicast-routing
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip multicast-routing
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip multicast-routing
DXS-3600-32S(config)#
29-3 show ip mroute
This command is used to display IP multicast routing information.
show ip mroute [{[GROUP-ADDRESS [SOURCE-ADDRESS] | dense | sparse | dvmrp | summary] | static}]
Parameters
GROUP-ADDRESS
SOURCE-ADDRESS
dense
sparse
dvmrp
summary
static
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
When IP multicast routing is disabled, the system will stop routing of multicast
packets even though the multicast routing protocol is enabled. If you want to use IP
multicast routing for forwarding, you need use the ip multicast-routing command to
enable global IP multicast routing state. When this command and any multicast
routing protocol are both enabled, IGMP will automatically be enabled on the
interface, and then the multicast routing forwarding can take effect.
To verify you configuration, use the command show ip multicast-routing.
This example shows how to enable global IP multicast routing.
This example shows how to disable global IP multicast routing.
Specifies the multicast group IP address.
Specifies the multicast source IP address.
Displays PIM-DM multicast routing table.
Displays PIM-SM multicast routing table.
Displays DVMRP multicast routing table.
Displays a one-line, abbreviated summary of each entry in the IP multicast routing
table.
Displays the multicast static routes
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
295