D-Link DXS-3600-16S Manual page 548

55-3 snmp-server name
This command is used to configure the system name information in global configuration mode. Use the no form of this
command to remove the configuration of system name information.
snmp-server name TEXT
no snmp-server name
Parameters
TEXT
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server name test
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no snmp-server name
DXS-3600-32S(config)#
55-4 snmp-server contact
This command is used to configure the system contact information in global configuration mode. Use the no form of this
command to remove the configuration of system contact information.
snmp-server contact TEXT
no snmp-server contact
Parameters
TEXT
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server contact test
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the string that describes the system name information. The maximum
length is 255 characters (please refer to RFC1213 for the maximum length in detail).
The syntax is general string that allows space.
No system name string is set.
Global Configuration Mode.
Level: 12
Configure the system name information on the switch.
This example shows how to set up the system name information with string test.
This example shows how to set system name information to default value.
Specifies the string that describes the system contact information. The maximum
length is 255 characters (please refer to RFC1213 for the maximum length in detail).
The syntax is general string that allows space.
No system contact string is set.
Global Configuration Mode.
Level: 12
Configure the system contact information on the switch.
This example shows how to set up the system contact information with string test.
540