D-Link DXS-3600-16S Manual page 267

no ip igmp query-interval
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip igmp query-interval 120
DXS-3600-32S(config-if)#
23-5 ip igmp query-max-response-time
This command is used to configure the maximum response interval. Use the no form of this command to set the
maximum response interval to the default value.
ip igmp query-max-response-time seconds
no ip igmp query-max-response-time
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip igmp query-max-response-time 20
DXS-3600-32S(config-if)#
23-6 ip igmp robustness-variable
This command is used to change the value of the robustness variable. Use the no form of this command to restore it to
the default value.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the query interval of ordinary member, in second. The range is 1 to 31744
seconds.
125 seconds.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The time to query an ordinary member can be changed by configuring the query
interval of the ordinary member.
Use the show ip igmp interface command to verify your setting.
This example shows how to configure the query interval of ordinary member to 120
seconds on the interface VLAN 1.
Specifies the maximum response interval, in second. The range is 1 to 25 seconds.
10 seconds.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command controls the interval for the respondent to respond the query
message before the device deletes the group information.
Use the show ip igmp interface command to verify your setting.
This example shows how to configure the maximum response interval to 20 seconds
on the interface VLAN 1.
259