D-Link DXS-3600-16S Manual page 486

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/3
DXS-3600-32S(config-if)#queue 1 bandwidth 100 2000
DXS-3600-32S(config-if)#
48-14 rate-limit
This command is used to configure the rate limitation on the interface. Use the no form of the command to restore it to
the default setting.
rate-limit {input | output} bps burst-size
no rate-limit {input | output}
Parameters
input
output
bps
burst-size
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/3
DXS-3600-32S(config-if)#rate-limit input 2000 4096
DXS-3600-32S(config-if)#
48-15 service-policy
This command is used to apply a policy map defined by the policy-map command to an interface. Use the no form of
this command to remove the policy map from interface.
service-policy {input | output} policy-map-name
no service-policy {input | output}
Parameters
input
output
policy-map-name
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to set the queue bandwidth.
Specifies the input rate limit.
Specifies the output rate limit.
Specifies the bandwidth limitation in Kbps.
Specifies the burst traffic limit in Kbyte.
No limitation.
Interface Configuration Mode.
Level: 15
Only physical ports are valid for this command.
This example shows how to set the input bandwidth on interface tenGigabitEthernet
1/0/3.
Specifies to apply the policy map for ingress flow on interface.
Specifies to apply the policy map for egress flow on interface.
Specifies the name of the policy map. The name can be a maximum of 32
alphanumeric characters.
None.
Interface Configuration Mode.
Level: 15
478