D-Link DXS-3600-16S Manual page 357

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# interface vlan 10
DXS-3600-32S(config-if)# mpls ldp hello-holdtime 30
DXS-3600-32S(config-if)#
38-11 mpls ldp hello-interval
This command is used to configure the LDP link hello interval time for the interface. Use the no form of this command
to restore the default value.
mpls ldp hello- interval SECONDS
no mpls ldp hello- interval
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# interface vlan 10
DXS-3600-32S(config-if)# mpls ldp hello-interval 10
DXS-3600-32S(config-if)#
38-12 mpls ldp targeted-hello-accept
This command is used to set the targeted hello message acceptable on this interface. Use the no form of this
command to deny the targeted hello message acceptable.
mpls ldp targeted-hello-accept
no mpls ldp targeted-hello-accept
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 15.
This command only can be applied on a Layer 3 VLAN interface. LDP sends link
hello message periodically to discovery its directly connected neighbors. LDP
maintains a hold timer for each discovered neighbor. If the timer expires without
receipt of hello from the neighbor, LDP concludes that the neighbor has failed.
This example shows how to configure the hello hold time of the VLAN 10 interface to
30 seconds.
Specifies the link hello interval time in seconds. The range is 1-65535 seconds.
5 seconds.
Interface Configuration Mode.
Level: 15.
This command only can be applied on a Layer 3 VLAN interface. Use the mpls ldp
hello-interval command to configure the LDP link hello interval time for the
interface. LDP sends link hello message according the hello interval period. The
hello interval time on the interface shall less than its hello hold-time. It is
recommend to set the hello interval time less than one third of the hello hold-time.
This example shows how to configure the hello interval time of the VLAN 10 interface
to 10 seconds.
None.
Enabled.
Interface Configuration Mode.
Level: 15.
349