D-Link DXS-3600-16S Manual page 324

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no lldp tlv-select system-name
DXS-3600-32S(config-if)#
32-13 lldp dot1-tlv-select
This command is used to specify which optional type-length-value settings (TLVs) in the IEEE 802.1 Organizationally
Specific TLV set will be transmitted and encapsulated in the LLDPDUs and sent to neighbor devices. To disable
transmit the TLVs, use the no form of this command.
lldp dot1-tlv-select {port-vlan_id | port-and-protocol-vlan-id interface INTERFACE-ID [, | -] | vlan-name
interface INTERFACE-ID [, | -] | protocol-identify {EAPOL | lacp | gvrp | stp}}
no lldp dot1-tlv-select {port-vlan_id | port-and-protocol-vlan-id interface INTERFACE-ID [, | -] | vlan-name
interface INTERFACE-ID [, | -] | protocol-identify {EAPOL | lacp | gvrp | stp}}
Parameters
port-vlan-id
port-and-protocol-vlan-id Specifies the Port And Protocol VLAN ID TLV to send and receive. The Port and
vlan-name
protocol-identify
interface INTERFACE-ID
,
-
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to disable System Name TLV advertisement.
Specifies the Port VLAN ID TLV to send or receive. The Port VLAN ID TLV is an
optional fixed length TLV that allows a VLAN bridge port to advertise the port's VLAN
identifier (PVID) that will be associated with untagged or priority tagged frames.
Protocol VLAN ID TLV is an optional TLV that allows a bridge port to advertise a port
and protocol VLAN ID.
Specifies the VLAN Name TLV to send or receive. The VLAN Name TLV is an
optional TLV that allows an IEEE 802.1Q-compatible IEEE 802 LAN station to
advertise the assigned name of any VLAN with which it is configured.
Specifies the Protocol Identity TLV to send or receive. The Protocol Identity TLV is an
optional TLV that allows an IEEE 802 LAN station to advertise particular protocols
that are accessible through the port.
This TLV optional data type indicates whether the corresponding Local System's
Protocol Identity instance will be transmitted on the port. The Protocol Identity TLV
provides a way for stations to advertise protocols that are important to the operation
of the network. Such as Spanning Tree Protocol, the Link Aggregation Control
Protocol, and numerous vendor proprietary variations are responsible for
maintaining the topology and connectivity of the network. If EAPOL, GVRP, STP
(including MSTP), and LACP protocol identity is enabled on this port and it is
enabled to be advertised, then this protocol identity will be advertised.
Specifies the valid VLAN interface.
(Optional) Specifies a series of physical interfaces. No space before and after the
comma.
(Optional) Specifies a range of physical interfaces. No space before and after the
hyphen.
No IEEE 802.1 Organizationally specific TLV is selected.
Interface Configuration Mode.
Level: 12
316