D-Link DXS-3600-16S Manual page 569

57-8 instance
This command is used to map a VLAN or a set of VLANs to an MST instance. To return the VLANs to the default
instance (CIST), use the no instance INSTANCE-ID vlans VLANDID [,|.] command. Use the no instance INSTANCE-
ID command to delete an MST instance.
instance INSTANCE-ID vlans VLANDID [,|.]
no instance INSTANCE-ID [vlans VLANDID [,|.]]
Parameters
INSTANCE-ID
vlans VLANDID [,|.]
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree mst configure
Success
DXS-3600-32S(config-mst)#instance 2 vlans 1-100
Success
DXS-3600-32S(config-mst)#
57-9 name
This command is used to set the name of an MST region. To return to the default name, use the no form of this
command.
name NAME
no name
Parameters
NAME
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the MSTP Instance identifier to which the specified VLANs are mapped.
The instance 0 represents for default instance, CIST.
Specifies the number of the VLANs to be mapped to the specified instance. Valid
values are from 1 to 4094.
All VLANs are mapped to the CIST instance in default.
MST Configuration Mode.
Level: 8
This command is used to map VLANs to the MST instance.
When mapping VLAN(s) to a MST instance, if this instance is not exist, this instance
will be created automatically. User can use no instance INSTANCE-ID command to
delete a MST instance manually.
This example shows how to map a range of VLANs to instance 2.
Specifies the name given for a specified MST region. The name string has a
maximum length of 32 characters.
The default value for name is the Bridge MAC Address.
MST Configuration Mode.
Level: 8
561