Priority-Based Flow Control (Pfc) Commands - D-Link DXS-3600-16S Manual

Priority-based Flow Control (PFC) Commands

45-1 clear priority-flow-control counters
This command is used to clear the Priority-based Flow Control (PFC) counters of specified interface(s).
clear priority-flow-control counters [INTERFACE-ID [, | -]] {rx | tx | both}
Parameters
INTERFACE-ID
,
-
rx
tx
both
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#clear priority-flow-control counters interface gigabitEthernet 1/1/1 tx
DXS-3600-32S#
45-2 priority-flow-control willing
This command is used to turn on the Priority Flow Control (PFC) willing feature. When enabled, the system will use
Data Center Bridging Exchange (DCBX) to detect remote systems and accept a PFC configuration from them.
priority-flow-control willing
no priority-flow-control willing
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies that the valid interface is a physical interface.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specifies a range of interfaces. No space before and after the hyphen.
Specifies to clear the counter of received PFC frames.
Specifies to clear the counter of transmitted PFC frames.
Specifies to clear the counter of received and transmitted PFC frames.
None.
Privileged EXEC Mode.
Level: 3.
You can use this command to clear PFC counters of requests and indications on the
specified interface(s). If no interface is specified, the counters on all interfaces will be
cleared.
This example shows how to clear the counter of transmitted PFC frames on the
interface 1/1/1.
None.
Disabled
Interface Configuration Mode.
Level: 3.
436