D-Link DXS-3600-16S Manual page 296

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip address dhcp
DXS-3600-32S(config-if)#
27-3 ip directed-broadcast
This command is used to enable forwarding of IP directed broadcasts on an interface where the broadcast becomes a
physical broadcast. Use no command to disable forwarding of IP directed broadcasts on an interface.
ip directed-broadcast
no ip directed-broadcast
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 100
DXS-3600-32S(config-if)#ip directed-broadcast
DXS-3600-32S(config-if)#
27-4 ip default-gateway
This command is used to set a default gateway address for the out-band interface. Use no command to remove the
default gateway address.
ip default-gateway ip-address
no ip default-gateway ip-address
Parameters
ip-address
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to make the interface of VLAN 1 obtain an IP address
automatically.
None.
By default, this option is disabled.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command enables the forwarding of IP directed broadcast on an interface
where the broadcast becomes a physical broadcast.
The no form of this command disables the forwarding of IP directed broadcast on an
interface.
Users can verify the settings by entering the show ip interface command.
This example shows how to enable the IP directed broadcast on interface VLAN
100.
Specifies the IP address of the default gateway.
There is no default gateway defined for out-band interface.
Interface Configuration Mode.
Level: 8
288