D-Link DXS-3600-16S Manual page 347

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#monitor session 1 source interface tenGigabitEthernet 1/0/1-1/0/3
DXS-3600-32S(config)#monitor session 1 destination interface tenGigabitEthernet 1/0/9 acl
mac_based_mirr
DXS-3600-32S(config)#monitor session 2 destination interface tenGigabitEthernet 1/0/21
DXS-3600-32S(config)#monitor session 2 source interface tenGigabitEthernet 1/0/5 rx
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no monitor session 1 source interface tenGigabitEthernet 1/0/3 rx
DXS-3600-32S(config)#no monitor session 2
DXS-3600-32S(config)#
36-2 no monitor session all
This command is used to delete all the monitor sessions directly.
no monitor session all
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no monitor session all
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Number of mirror ports are 4 MTPs, MTPs port can be same or different. For a
mirrored packet, do no VLAN membership check, MTP port need not be member of
all VLANs. An MTP port can be a logical port, if for trunk.
If the source ports overlapped with the destination trunk member ports while
configure mirror session, the switch can be configured successfully and that the
mirror cannot be worked well.
The flow-based mirror also can be supported, but only is ingress mirror. It will not
affect mirror function and can be worked well simultaneously.
You will remove the whole session if you do not specify the source port or the
destination port.
Use show monitor to display mirror session configurations.
This example shows how to create mirror sessions:
Session 1: The source ports are 1-3, destination port is 9, RX and TX traffic are
mirrored, the name of the ACL mirror is 'mac_based_mirr'.
Session 2: The source port is 5, destination port is 21 and it is a member of trunk
group 1, only RX traffic are mirrored.
This example shows how to remove mirror sessions:
Session 1: Remove RX mode of mirrored traffic for the source port 3.
Session 2: Remove the whole mirror session 2.
None.
All the monitor sessions are removed.
Global Configuration Mode.
Level: 12
The command can be used to remove all the mirror sessions, and include bonded
flow_based mirrors.
This example shows how to remove all the mirror sessions.
339