D-Link DXS-3600-16S Manual page 466

ip pim ssm {default | range ACCESS-LIST}
no ip pim ssm
Parameters
ACCESS-LIST
default
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim ssm default
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim ssm range ssm-acl
DXS-3600-32S(config)#ip standard access-list ssm-acl
DXS-3600-32S(config-ip-acl)#permit 239.0.0.0/11
DXS-3600-32S(config-ip-acl)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim ssm
DXS-3600-32S(config)#
47-13 show ip pim dense-mode interface
This command is used to display information about PIM-DM interface.
show ip pim dense-mode interface [IFNAME [detail]]
Parameters
IFNAME
detail
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies a standard IP access list that defines the user-specified SSM group
addresses.
Specifies to use the default SSM group addresses. The default SSM group address
range is 232/8.
PIM SSM is disabled.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
For an SSM group, the switch will use (S, G) in IGMPv3 report to join SPT. And if the
group address of configured range is reported by IGMPv1/v2, it will be ignored by
IGMP module. If the ACL entry configured for SSM group address range includes
multiple networks, only the first group network will work.
To verify your configuration, use command show ip pim.
This example shows how to configure the PIM SSM function enable, use default
group address range.
This example shows how to configure the PIM SSM function enable, and group
address range is 239.0.0.0/11
This example shows how to disable the PIM SSM function.
Specifies the interface name to be displayed. If no interface name, display all PIM-
DM interfaces.
Displays the detailed information.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
458