D-Link DXS-3600-16S Manual page 122

ospf
NUMBER
MAP-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router bgp 100
DXS-3600-32S(config-router)#redistribute rip metric 2000 route-map my-may
DXS-3600-32S(config-router)#
7-65 route-preference
This command is used to set the BGP route preference. Use the no form of this command to restore the default value
of the BGP route preference.
route-preference {ibgp | ebgp} value
no route-preference
Parameters
value
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to redistribute OSPF routes to BGP.
all - Specifies to redistribute both OSPF AS-internal and OSPF AS-external
routes to BGP.
internal - Specifies to redistribute only the OSPF AS-internal routes.
external - Specifies to redistribute only the OSPF AS-external routes, including
type-1 and type-2 routes.
type_1 - Specifies to redistribute only the OSPF AS-external type-1 routes.
type_2 - Specifies to redistribute only the OSPF AS-external type-2 routes.
inter+e1 - Specifies to redistribute only the OSPF AS-external type-1 and OSPF
AS-internal routes.
inter+e2 - Specifies to redistribute only the OSPF AS-external type-2 and OSPF
AS-internal routes.
(Optional) Specifies the BGP metric value for the redistributed routes. Enter the
metric value used here. This value must be between 0 and 4294967295.
(Optional) Specifies a route map which will be used as the criteria to determine
whether to redistribute specific routes. Enter the route map name used here. This
name can be up to 16 characters long.
By default, this option is disabled.
Router Configuration Mode.
Address Family Configuration Mode (IPv4 Unicast and VRF).
Level: 8. (EI Mode Only Command)
When a switch supports multiple routing protocols, the coordination between these
protocols becomes an important task. This command is used for redistribute prefixes
from other routing protocols to BGP.
You can verify your settings by entering show ip bgp parameters command.
This example shows how to redistribute RIP route to BGP and use the optional
parameters to modify the routes.
Specifies the preference of the BGP route. The value range is 1-999.
The default route-preference for EBGP is 70 and IBGP is 130.
Router Configuration Mode.
Address Family Configuration Mode (VRF).
Level: 8. (EI Mode Only Command)
114