D-Link DXS-3600-16S Manual page 416

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf interface
DXS-3600-32S#
intf 10.1.1.1 up tic 10
intf 100.1.1.1 down tic 20
OSPF: Select DR: 2.2.2.2
OSPF: Select BDR: 1.1.1.1
40-34 debug ip ospf lsa-originating
This command is used to turn on the OSPF LSA originating debug switch. Use the no form of the command to turn off
the OSPF LSA originating debug switch.
debug ip ospf lsa-originating
no debug ip ospf lsa-originating
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf lsa-originating
DXS-3600-32S#
Build Router LSA id 100.1.1.2 for area 0.0.0.0 seq 80000001 tic 10
40-35 debug ip ospf lsa-flooding
This command is used to turn on the OSPF LSA flooding debug switch. Use the no form of the command to turn off the
OSPF LSA flooding debug switch.
debug ip ospf lsa-flooding
no debug ip ospf lsa-flooding
Parameters
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
By default, the OSPF interface state debug switch is turned off.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on or turn off OSPF interface state debug switch. When
OSPF interface state changes or some events happen to change interface state,
debug information will print. When DR selection happens, debug information will also
print if OSPF debug function is turned on.
Use the command debug ip ospf to turn on the OSPF debug function.
This example shows how to turn on the OSPF interface state debug switch.
None.
By default, the OSPF LSA originating debug switch is turned off.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on or turn off OSPF LSA originating debug switch. When
LSA is originated, debug information will be print if OSPF debug function is turned
on.
Use the command debug ip ospf to turn on the OSPF debug function.
This example shows how to turn on the OSPF LSA originating debug switch.
None.
408