Administering the Device
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Configuring a System Name
Follow these steps to manually configure a system name:
Procedure
Step 1
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
interface interface-id
Example:
Device(config)# interface
gigabitethernet1/0/1
[no] ntp disable
Example:
Device(config-if)# ntp disable
end
Example:
Device(config-if)# end
Command or Action
enable
Example:
Device> enable
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Configuring a System Name
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Enters global configuration mode.
Disables NTP packets from being received on
the interface.
Use the no form of this command to re-enable
receipt of NTP packets on an interface.
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
21