Configuring A System Name - Cisco Catalyst 9200 Configuration Manual

Configuring a System Name

SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. [no] ntp disable
5. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
interface interface-id
Example:
Device(config)# interface gigabitethernet1/0/1
Step 4 [no] ntp disable
Example:
Device(config-if)# ntp disable
Step 5 end
Example:
Device(config-if)# end
Configuring a System Name
Follow these steps to manually configure a system name:
SUMMARY STEPS
1. enable
2. configure terminal
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
24
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Enters global configuration mode.
Disables NTP packets from being received on the interface.
Use the no form of this command to re-enable receipt of
NTP packets on an interface.
Returns to privileged EXEC mode.
Administering the Device