Vrrp Timers Advertise - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

19-6 vrrp timers advertise

vrrp VRID timers advertise INTERVAL
no vrrp VRID timers advertise
Syntax Description
VRID
INTERVAL
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# vrrp 7 timers advertise 10
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# no vrrp 7 timers advertise
CLI Reference Guide
Use this command to configure the interval between successive VRRP
advertisements by the master router. Use the no form of this command to restore
to the default value.
Specifies the virtual router identifier. The valid range is from 1 to 255.
Specifies the time interval between successive advertisements by the master
router. The unit of the interval is second.The valid value is from 1 to 255.
The default value of advertisement interval is 1 second.
Interface configuration mode.
The maser will constantly send the VRRP advertisements to communicate the
related information of the current master virtual router.
The vrrp timers advertise command configures the interval between advertisement
packets and the time before other routers declare the master router as down. All
routers in a VRRP group must use the same timer values.
Use the command show vrrp to verify your settings.
In the following example, the user configures the router to send advertisements for
VRRP 7 every 10 seconds on interface vlan1:
In the following example, the user configures the advertisement interval to use the
default settings:
vrrp timers advertise
514